Altronix MAXIMAL33RD Rack Mount Access Power Controller, 12A @ 12VDC and/or 24VDC, 16 PTC Outputs
|Part Number: MAXIMAL33RD|
Rack Mount Access Power Controller, 12A @ 12VDC and/or 24VDC, 16 PTC Outputs
Maxim33RD units distribute and switch power to access control systems and accessories. They convert a 115VAC 50/60Hz input into sixteen (16) independently controlled 12VDC and/or 24VDC PTC protected outputs. Outputs are activated by an normally open (NO) or normally closed (NC) dry trigger input from an Access Control System, Card Reader, Keypad, Push Button, PIR, etc. Units will route power to a variety of access control hardware devices including: Mag Locks, Electric Strikes, Magnetic Door Holders, etc. Outputs will operate in both Fail-Safe and/or Fail-Secure modes. The FACP Interface enables Emergency Egress, Alarm Monitoring, or may be used to trigger other auxiliary devices. The fire alarm disconnect feature is individually selectable for any or all of the outputs (see chart below).
12 amp @ 12VDC and/or 24VDC output.
2.0 amp max. current per output.
Sixteen (16) PTC protected outputs.
115VAC 50/60Hz. input
Normally closed [NC] or normally open [NO] dry contact inputs
Individually selectable, Mag Lock/Strike (Fail-Safe, Fail-Secure)
solid state fuse protected power outputs.
Fire Alarm disconnect (latching with reset or non-latching) is individually
selectable for any or all of the outputs.
Fire Alarm disconnect input options:
a) Normally open [NO] or normally closed [NC] dry contact input.
b) Polarity reversal input from FACP signaling circuit.
Remote reset capability for latching Fire Alarm Interface mode
Filtered and electronically regulated outputs.
Short circuit and thermal overload protection.
Removable terminal blocks with locking screw flange.
3-wire line cord.
Illuminated master power switch.
Built-in charger for sealed lead acid or gel type batteries.
Zero voltage drop upon transfer to battery backup.
Automatic switch over to stand-by battery when AC fails.
AC fail, low battery and battery presence supervision.
Individual output status LEDs located on the front panel.
Modular 2U standard EIA 19 rack mount chassis.
Dimensions: 3.25H x 19.125W x 8.5D.
Allow 1/2U space on top and bottom of the unit for ventilation.