Altronix STRIKEIT4 Low Current Locking Device Power Controller

Altronix STRIKEIT4 Low Current Locking Device Power Controller

• Input

  • Input 115VAC, 60Hz, 2.5A or 230VAC, 50Hz, 1.5A.
  • Two (2) Normally Open (N.O.) trigger inputs (Input 1 and Input 2).
  • FACP Normally Closed (N.C.) input.
  • Two normally open ADA inputs for special mode of interfacing with automatic door operators.

• Outputs

  • Two (2) 19.8VDC-26.4VDC rated individually controlled lock outputs configurable for fail-secure or fail-safe electronic locking hardware for applications with battery back-up. 24VDC-26.4VDC rated for applications without battery back-up (US applications only). Current rating 2A combined.
  • One (1) 19.8VDC-26.4VDC @ 0.8A rated filtered regulated auxiliary output for applications with battery back-up, 24VDC-26.4VDC @ 0.8A rated for applications in US not requiring battery back-up. Not affected by FACP trigger.
  • One (1) 12VDC filtered regulated auxiliary output rated 0.5A. Not affected by FACP trigger.
  • Two (2) follower Normally Open relay outputs for controlling ADA actuators/accessories rated 28VDC @ 0.5A.
  • Two momentary door operator activation relay outputs.
  • Trouble relay output indicating low AC voltage trouble and battery trouble.

• Battery Backup

  • Battery leads included.
  • When 7AH batteries are used, battery capacity for emergency stand-by is 30 minutes.
  • Built-in charger for sealed lead acid batteries.
  • Maximum charge current 650mA.
  • Automatic switch over to stand-by battery when AC fails.

• Visual Indicators

  • Green AC Power LED indicates AC presence.
  • Red trigger output LEDs indicate panic device status / opened (activated, short circuit).
  • Green Fire Alarm Interface (FAI) LED indicates FACP interface is activated.
  • Red Battery LED indicates low battery during AC failure and battery test.
  • Green AC status LED indicates loss of AC power.

• Fire Alarm Disconnect

  • Normally Closed FACP trigger input.

  • Programmable Fire Alarm Disconnect options:

    • Removes power to outputs and disables delayed follower relays.
    • Connects power to lock outputs and enables delayed follower relays.